ISPRouter show Command Trainer

Click a question → watch the terminal show you exactly where the answer lives.

Learn
Quiz me
Score: 0/0
Learn mode: click a question, the answer highlights instantly in the terminal below. Quiz me mode: click a question, pick which command(s) you think answer it, then check — the terminal only reveals the highlight after you check.

Part 2 Questions

← Pick a question to begin. Its answer will highlight in the terminal on the right.

Terminal — ISPRouter
command that answers the question exact line with the answer
ISPRouter>enable

ISPRouter#show arp Protocol Address Age (min) Hardware Addr Type Interface Internet 209.165.201.1 - 0030.F275.CE01 ARPA GigabitEthernet0/0
ISPRouter#show flash: System flash directory: File Length Name/status 3 33591769 c1900-universalk9-mz.SPA.151-4.M4.bin 2 28282 sigdef-category.xml 1 227537 sigdef-default.xml [33847587 bytes used, 221896413 available, 255744000 total] 249856K bytes of processor board System flash (Read/Write)
ISPRouter#show ip route Codes: L - local, C - connected, S - static, R - RIP, M - mobile, B - BGP D - EIGRP, EX - EIGRP external, O - OSPF, IA - OSPF inter area N1 - OSPF NSSA external type 1, N2 - OSPF NSSA external type 2 E1 - OSPF external type 1, E2 - OSPF external type 2, E - EGP i - IS-IS, L1 - IS-IS level-1, L2 - IS-IS level-2, ia - IS-IS inter area * - candidate default, U - per-user static route, o - ODR P - periodic downloaded static route Gateway of last resort is not set 209.165.200.0/24 is variably subnetted, 2 subnets, 2 masks C 209.165.200.224/27 is directly connected, Serial0/0/1 L 209.165.200.226/32 is directly connected, Serial0/0/1 209.165.201.0/24 is variably subnetted, 2 subnets, 2 masks C 209.165.201.0/27 is directly connected, GigabitEthernet0/0 L 209.165.201.1/32 is directly connected, GigabitEthernet0/0
ISPRouter#show interfaces GigabitEthernet0/0 is up, line protocol is up (connected) Hardware is CN Gigabit Ethernet, address is 0030.f275.ce01 (bia 0030.f275.ce01) Internet address is 209.165.201.1/27 MTU 1500 bytes, BW 1000000 Kbit, DLY 10 usec, reliability 255/255, txload 1/255, rxload 1/255 Encapsulation ARPA, Loopback not set Keepalive set (10 sec) Full Duplex, 100Mbps, link type is auto, media type is RJ45 ARP type: ARPA, ARP Timeout 04:00:00, Last input 00:00:08, output 00:00:05, output hang never Input queue: 0/75/0 (size/max/drops); Total output drops: 0 5 minute input rate 0 bits/sec, 0 packets/sec 5 minute output rate 0 bits/sec, 0 packets/sec 0 packets input, 0 bytes, 0 no buffer 0 broadcasts, 0 runts, 0 giants, 0 throttles 0 input errors, 0 CRC, 0 frame, 0 overrun, 0 ignored, 0 abort
ISPRouter#show ip interface brief Interface IP-Address OK? Method Status Protocol GigabitEthernet0/0 209.165.201.1 YES manual up up GigabitEthernet0/1 unassigned YES unset administratively down down Serial0/0/0 unassigned YES unset administratively down down Serial0/0/1 209.165.200.226 YES manual up up Vlan1 unassigned YES unset administratively down down
ISPRouter#show protocols Global values: Internet Protocol routing is enabled
ISPRouter#show users Line User Host(s) Idle Location * 0 con 0 idle 00:00:00 Interface User Mode Idle Peer Address
ISPRouter#show version Cisco IOS Software, C1900 Software (C1900-UNIVERSALK9-M), Version 15.1(4)M4, RELEASE SOFTWARE (fc2) Technical Support: http://www.cisco.com/techsupport Copyright (c) 1986-2007 by Cisco Systems, Inc. Compiled Wed 23-Feb-11 14:19 by prod_team ROM: System Bootstrap, Version 15.1(4)M4, RELEASE SOFTWARE (fc1) cisco1941 uptime is 41 minutes, 39 seconds System returned to ROM by power-on System image file is "flash0:c1900-universalk9-mz.SPA.151-4.M4.bin" Last reload type: Normal Reload